|
LP Muli-Pro DDP 1.5 400V/50Hz
Item number 0175.13.21 Dimensions including packaging 1500 x 780 x 1550 mm; 495 kg
€25,277.14 / Pcs
Tender text
ACO Muli-Pro DDP 1.5
Waste water and faeces lifting plant
ACO Passavant waste water lifting plant
MULI- PRO-PE mono,
ready to plug in, for disposal of waste
water and faeces
below backflow level, consisting of:
Storage tank of polyethylene, length
1440 mm,width 780 mm,
height 1035 mm, with drain plug and
connection for manual
diaphragm pump R 1 1/2, 1 set fixing
screws with washers and
dowels for buoyancy-safe anchoring.
Effective capacity of tank duo designe;
with inlet height
600mm = 240 litres, with inlet height
750mm = 305 litres,
with inlet height 800mm or from above =
330 litres,
total volume: 520 litres,
Tank with revision openings clear
opening 320 mm
Connection inlet pipe: suitable for
plastic or SML pipe,
1 x inlet DN 150, inlet height 600 mm, 2
x inlet DN 150,
inlet height 750 mm, 1 x inlet DN 150,
inlet height 800 mm,
1 x inlet DN 150 from above, inlet
height 1015 mm
Connection pressure pipe: 2 special
backflow stops DN 80
resp. DN 100 with lift up devise, with
connection
possibility of a pressure gauge, with
bifurcated pipe (Duo
design) with special fastening component
for connection of
pressure pipe DN 100 (pipe outer dia.
108
- 112 mm)
Connection ventiltion pipe: socket DN
100 suitable for
plastic or SML pipe
2 direct- connected motor- driven pumps,
consisting of:
Floodable 3- phase motor:
8.97 kW (P1),7.5 kW (P2), operating
voltage 400 V, 50 Hz,
1450. revolutions/min, protection type
IP 68 with 1 shaft
sealing ring und 1 circular rotating
mechanical seal, with
channel impeller or torque flow impeller
with 80 mm grain
size.
Pneumatic level switch: pressure tube
for ON- OFF- ALARM 1
with pneumatic control cable and mini
compressor "air bubble
injection" (as protection against media
generating floating
surfaces, e. g. greasy wate water) and
seperate pressure
tube for ALARM 2.
Switchgear microproessor- controlled
with digital display
for alternating operation of both pumps
(duo) as well as for
automatic switching- on of spare pump in
the case of peak
load: ready to plug in with 1.5 m cable
with CEE plug 16 A,
5- polar, ISO housing with transparent
cover, protection
type IP 54, with mains-controlled signal
unit "visual and
audible", with potential- free colletive
fault signal, with
potential- free operating signal, with
retro- fit
possibility (accumulator) for
mains-independent fault signal
(see accessories). With double alarm
signal: 1 x via
pressure tube ON- OF- ALARM 1 (value
adjustable via
potentiometer) and 1 x via separate
pressure tube ALARM 2
(separate system with firmly adjusted
value).
The switchbox is connected to the
lifting plant by a 4 m
pneumatic control cable and motor cable.
Weight approx 510 kgs